Managing Basic Operations
Part # 910-250C
23
Indicates the EPOCH 4PLUS is in the Echo-to-Echo measurement
mode and the measurement is being made between the leading edges of
the two selected signals.
P Indicates the Peak Memory function is active.
PH Indicates the Peak Hold function is active.
F Indicates the display is frozen because the Freeze function is active.
Z Indicates the Zoom function is active to expand the region within the
flaw gate to full screen width.
A Indicates the gate alarm is tripped.
TVG Indicates Time Varied Gain is active.
DAC Indicates Distance Amplitude Correction is active.
CSC Indicates Curved Surface Correction is active.
SW Indicates Spotweld Overlay is active.
SWA Indicates Spotweld Assistant is active.
IF Indicates Interface Gate is active.
WV Indicates Wave Analysis is active.
AWS Indicates AWS software is active.
* Indicates Auto Freeze option is active.
BEA Indicates Backwall Echo Attenuation is active.
API Indicates API software is active.
PRF Indicates either Low PRF or High PRF Option is active.
DGS Indicates DGS (Distance Gain Sizing) is active.
Indicates the remaining battery life in the unit. The battery level is
constantly displayed in the lower right corner of the display.
3.7 Setting-up Parameters
The EPOCH 4PLUS Setup screen allows you to select basic system parameters. To access
the Setup screen, press [OPTION]. Move the highlight bar over Setup and press
[ENTER]. The following screen appears:
To Next Page
Loading...
