Olympus Panametrics Epoch 4 Plus - 9.17.6 API 5 UE and the EPOCH 4 PLUS Datalogger

158
EPOCH 4PLUS
Figure 113 Crack Size Indication (cont.)
Figure 114 Crack Size Indication (cont.)
To inspect a separate crack or to collect new data for the same crack, press CLEAR [F5]
and follow the steps above to inspect again.
Note: At any time during an inspection in either Envelope Mode or Manual Mode,
it is possible to re-calibrate the instrument. Press the RE-CAL key [F1] to
enter calibration mode and follow the steps in Calibrating to a Reference
Standard to re-calibrate the EPOCH 4PLUS.
9.17.6 API 5UE and the EPOCH 4PLUS Datalogger
API 5UE calibrations and inspection data can be stored easily using the EPOCH 4PLUS
datalogger. If data is saved using the [SAVE THICK] key, the instrument saves only the
file name, ID, and captured indication depth (from standard thickness measurement). If
data is saved using the [SAVE WAVE] key, the instrument saves the file name, ID,
reference values for A
max
, T
1
, T
2
, and reference notch height, indication values for A
max
,
T
1
, T
2
and indication crack height, all instrument setup parameters, and the A-Scan.
Data may be transferred to a PC for storage and reporting via the EPOCH 4PLUS
GageView Pro interface program.