17
4.3 Setup and Operation Using the iServer Web Page
• Start your web browser.
• From the browser you type http://eisxxxx using the last four-digits from the MAC
address label located on the device if DHCP and DNS are used. If a static IP address
is used, then simply type http://x.x.x.x, where x.x.x.x is the iServer’s IP address.
• The Home Page, shown in Figure 4.5, will be displayed.
Figure 4.5 iServer Home Page
In order to access certain menu items of the Home Page, users may be
prompted for a password, as shown in Figure 4.6.
Figure 4.6 LOGIN and ADMINISTRATOR Passwords
There are 2 different access levels:
1. ADMINISTRATOR Password (administrator) allows certain groups and individual users to
access and modify "entire" iServer parameters without any restrictions.
The default password is 00000000. This password can be up to 16 alphanumeric case-
sensitive characters.
2. LOGIN Password (operator) allows users to access and modify all of the iServer’s
parameters, except “Access Control” which requires an Administrator
password. The "Read Sensor" does not require a password.
The default password is 12345678. This password can be up to 16 alphanumeric
case-sensitive characters.
ADMINISTRATOR
ADMINISTRATOR
LOGIN
LOGIN
http://192.168.1.200 http://192.168.1.200
iSERVER HOME PAGE
Firmware Version x.x
http://192.168.1.200
iServer Home Page
Read Sensor
Access Control
Chart
Configuration
To Next Page
Loading...
Need help?
General
