Award-winning Technology. The iServer is simple to install and use. It features award
winning technology that requires no special software except a Web browser. The iServer
connects to an Ethernet Network with a standard RJ45 connector and sends data in
standard TCP/IP packets. It is easily configured with a simple menu using a Web browser
and can be password protected. From within an Ethernet LAN or over the Internet, the user
simply types its IP address or an easy to remember name such as "Cleanroom 5" or
"Server Room" in any Web Browser, and the iServer serves a Web Page with the current
readings. The iServer comes complete with one temperature/humidity wand probe, full
documentation and software.
Alarms and Email. The device can trigger an alarm if temperature goes above or below
a set point that you determine. Your alarm can be sent by email to a single user or to a
group distribution list, including text messages to cell phones and PDA’s.
A standard web browser can be used to monitor and chart temperature and humidity. The
browser can also be used to configure the device’s IP address, passwords for access
and all configuration parameters. An iLD Big Display can display temperature and
humidity received from an iServer over the Ethernet or the Internet.
The following example illustrates how you can hookup an iServer and iLD to your
network:
Figure 1.1 iServer and iLD Big Display on the Ethernet Network
COL
ON
TX
RX
COMPUTER with
Standard Web Browser
and
3
To Next Page
Loading...
Need help?
General
