Test Set CMC 156
74
N
National standards........................................ 45
traceability ................................................. 19
Nominal frequency ........................................ 31
Nominal voltage ............................................ 31
binary inputs .............................................. 14
O
Operating threshold
binary inputs .............................................. 14
Operation ...................................................... 11
Opto-couplers ............................................... 14
Ordering notes .............................................. 64
Output frequency of transient signals ........... 17
Output power
current outputs .................................... 33, 50
Current outputs ......................................... 33
current outputs (EP) ............................ 49, 50
Current outputs (EP) ................................. 49
Output power of the internal current
amplifiers ............................................. 34, 36
Output power of the internal current
amplifiers (EP) ..............................51, 52, 54
Output signal path ........................................ 19
Outputs
analog ................................................. 32, 48
binary ........................................................ 37
binary outputs ........................................... 38
block diagram ............................................ 18
configuring ................................................ 18
current ....................................................... 33
current (EP) ............................................... 49
current outputs (EP) .................................. 50
interface to an external amplifier ............... 36
voltage ..................................................... 35
voltage (EP) .............................................. 53
Overtemperature
resulting in switching OFF ........................ 16
P
PC
communication with .................................. 13
Phase angle
ϕ ........................................ 32, 48
Phase error ............................................ 32, 48
Phase resolution .................................... 32, 48
Plugs
ordering notes on ..................................... 64
suppliers and manufacturers .............. 23, 26
Power
current outputs ................................... 33, 50
Current outputs ........................................ 33
current outputs (EP) ........................... 49, 50
Current outputs (EP) ................................ 49
Power consumption ..................................... 31
Power of the internal current
amplifiers ............................................ 34, 36
Power of the internal current
amplifiers (EP) .............................. 51, 52, 54
Power supply voltage
of the current amplifier ............................. 16
Principle block diagram ................................ 12
Processing of the measuring data ............... 11
Processor ..................................................... 13
Protection of the current and voltage
outputs ...................................................... 15