Omicron CMC 156 User Manual

Start-Up
9
2 Start-Up
2.1 System components
Before start-up, please verify that all system components are present:
• CMC 156 test set
• Mains cable
• Connection cable CMC 156 ↔ computer (25-pole)
• Connection cable CMC 156 ↔ test object:
These are provided by the user.
• Standard computer with a parallel interface
2.2 System Start
The instructions below can be followed if the computer is set up completely
and the software is installed properly.
1
 A description of the installation of the CMC software is found in your CMC
software manual, chapter 1 "Installation".
The following procedure is recommended to connect the system components:
Figure 1 Connection CMC 156 and computer
1
These instructions refer to a system including a computer and basic device CMC 156, i.e. without
additional amplifiers. If the system is to be operated with external amplifiers, please refer to the
instructions in your CMC SW user's manual, section "Configuring an external amplifier".

Omicron CMC 156 Specifications

General

Brand	Omicron
Model	CMC 156
Category	Measuring Instruments
Language	English