153
Remote Terminals Section 5-1
The following diagram shows the terminal arrangement and wiring for the
SRT@-ID04.
Note The V terminals (terminal numbers 4, 6, and 11) are all connected internally,
as are the G terminals (terminal numbers 3, 5, and 7). When I/O power is sup-
plied to terminals 11 and 3, power can be supplied to sensors from terminals
4 and 5 as well as 6 and 7.
When the power supply exceeds 1.0 A, provide an external power supply to
the I/O power supply instead of providing the supply from the terminals.
The following diagram shows the terminal arrangement and wiring for the
SRT@-ID04-1.
Note The V terminals (terminal numbers 4, 6, and 11) are all connected internally,
as are the G terminals (terminal numbers 3, 5, and 7). When I/O power is sup-
plied to terminals 11 and 3, power can be supplied to sensors from terminals
4 and 5 as well as 6 and 7.
When the power supply exceeds 1.0 A, provide an external power supply to
the I/O power supply instead of providing the supply from the terminals.
CompoBus/S 24 V DC
Brown
Black
Blue
Brown
Blue
Brown
Black
Blue
CompoBus/S
communications
CompoBus/S
communications
power supply
I/O power supply
NPN output 3-wired
sensor (photoelec-
tric or proximity
sensor)
2-wired sensor
(limit switch)
NPN output 3-wired
sensor (photoelec-
tric or proximity
sensor)
PNP output 3-wired
sensor (photoelec-
tric or proximity
sensor)
2-wired sensor
(limit switch)
Brown
Black
Blue
Brown
Blue
CompoBus/S
communications
CompoBus/S
communications
power supply
I/O power supply
CompoBus/S 24 V DC
To Next Page
Loading...
