209
Connector Terminals Section 5-2
b) Secure both sides of the Connector Terminal with two end plates.
2. Mounting on DIN Track with Connector Side Facing Upward (Mounting
Brackets A and B Required)
a) Secure Mounting Bracket A on the DIN Track with two Phillips screws.
b) Press the Connector Terminal down into Mounting Bracket A.
End Plates
Hook the bottom, then the top of
the end plate over the track, and
fasten with a screw.
Connector
side up
b. Hitch top hooks
onto DIN Track.
c. Secure Mounting Bracket A
on DIN Track with two
Phillips screws. These
screws are provided with
Mounting Bracket A.
Mounting Bracket A
a. Hitch bottom hooks
onto DIN Track.
DIN Track
b. Pressing the Connector
Terminal downward will
cause the DIN Track
mounting hooks to engage
automatically.
a. Hook the Connector
Terminal onto the inner
ridge.
DIN Track
Mountin
g Bracket A
To Next Page
Loading...
