Omron CJ1G/H-CPU series - Page 316

283
PLC Setup Section 7-1
7-1-2-8 Peripheral Port Tab Page
The following settings are valid when pin 4 on the DIP switch on the CPU Unit
is ON.
Host Link Settings
Communications Settings
Baud Rate (bps)
Format: Data Bits
Format: Stop Bits
Address in
Programming
Console
Settings Function Related
flags and
words
When set-
ting is read
by CPU Unit
Word Bit(s)
144 15 0: Standard*
1: PLC Setup (Cus-
tom)
Default: 0
*The default settings are for 1 start bit, 7
data bits, even parity, 2 stop bits, and a
baud rate of 9,600 bps.
A61901
(Peripheral
Port Settings
Changing
Flag)
At the next
cycle.
(Also can be
changed with
STUP (237).)
Address in
Programming
Console
Settings Function Related
flags and
words
When set-
ting is read
by CPU Unit
Word Bit(s)
145 0 to 7 00: 9,600 bps
01: 300 bps
02: 600 bps
03: 1,200 bps
04: 2,400 bps
05: 4,800 bps
06: 9,600 bps
07: 19,200 bps
08: 38,400 bps
09: 57,600 bps
0A: 115,200 bps
Default: 00
This setting is valid only when the communi-
cations mode is set to the Host Link mode.
These settings are also valid only when the
Peripheral Port Settings Selection is set to
1: PLC Setup.
A61901
(Peripheral
Port Settings
Changing
Flag)
At the next
cycle.
(Also can be
changed with
STUP (237).)
Address in
Programming
Console
Settings Func
tion Related
flags and
words
When set-
ting is read
by CPU Unit
Word Bit(s)
144 3 0: 7 bits
1: 8 bits
Default: 0
These settings are valid only when the com-
munications mode is set to Host link.
These settings are also valid only when the
Peripheral Port Settings Selection is set to
1: PLC Setup.
A61901
(Peripheral
Port Settings
Changing
Flag)
At the next
cycle.
(Also can be
changed with
STUP (237).)
Address in
Programming
Console
Settings Function Related
flags and
words
When set-
ting is read
by CPU Unit
Word Bit(s)
144 2 0: 2 bits
1: 1 bit
Default: 0
These settings are valid only when the com-
munications mode is set to Host link.
These settings are also valid only when the
Peripheral Port Settings Selection is set to
1: PLC Setup.
A61901
(Peripheral
Port Settings
Changing
Flag)
At the next
cycle.
(Also can be
changed with
STUP (237).)