Omron CJ1M-CPU22

148
Built-in Outputs Section 6-2
Stopping a Pulse Output
Change
direction
Not supported.
Change
pulse out-
put method
Not supported.
Operation Example applica-
tion
Frequency changes Description Procedure
Instruction Settings
Operation Example
application
Frequency changes Description Procedure
Instruction Settings
Stop pulse
output
Immediate
stop
Stops the pulse out-
put immediately.
SPED(885)
or ACC(888)
(Continu-
ous)
↓
INI(880)
•Port
•Stop
pulse out-
put
Stop pulse
output
Immediate
stop
Stops the pulse out-
put immediately.
SPED(885)
or ACC(888)
(Continu-
ous)
↓
SPED(885)
(Continu-
ous)
•Port
•Continu-
ous
•Target fre-
quency=0
Stop pulse
output
smoothly
Decelerate
to a stop
Decelerates the
pulse output to a
stop.
Note If ACC(888)
started the
operation, the
original
acceleration/
deceleration
rate will
remain in
effect.
If SPED(885)
started the
operation, the
acceleration/
deceleration
rate will be
invalid and
the pulse out-
put will stop
immediately.
SPED(885)
or ACC(888)
(Continu-
ous)
↓
ACC(888)
(Continu-
ous)
•Port
•Continu-
ous
•Target fre-
quency=0
Pulse frequency
Present frequency
Execution of INI(880)
Time
Pulse frequency
Present frequency
Execution of SPED(885)
Time
Pulse frequency
Present frequency
Execution of ACC(888)
Acceleration/
deceleration rate
(Rate set at the
start of the
operation.)
Target frequency = 0
Time