Omron CJ2 Series User Manual

7. EtherNet/IP Connection Procedure
12
5
Connect the LAN cable to the
EtherNet/IP port of the PLC, and
connect the USB cable to the
USB port. Connect the personal
computer, Switching Hub and
PLC as shown in 5.2. Device
Configuration.
6
Turn ON the power supply to the
PLC.
The set IP address is displayed
on the seven-segment LED
indicators from right to left.
Afterwards, the rightmost 8 bits
of the IP address are displayed
in hexadecimal during normal
operation.
USB cable
LAN cable
Switching Hub
PLC
CPU Unit
Power Supply Unit

Omron CJ2 Series Specifications

General

CPU Units	CJ2H, CJ2M
Data Memory Capacity	32K words (CJ2M), 128K words (CJ2H)
EtherNet/IP	Yes (some models)
I/O Capacity	Up to 2, 560 I/O points
Communication Ports	Ethernet, RS-232C
Expansion Units	Up to 40 expansion units
Programming Languages	Ladder diagram, Structured text, Function block diagram
Instruction Execution Speed	0.04 μs (basic instructions)
Serial Ports	1 (RS-232C)
Expansion Slots	Up to 10 (CJ2H)
Operating Temperature	0 to 55°C
Storage Temperature	-25°C to 75°C
Power Supply Voltage	100 to 240 VAC, 24 VDC