The Synchronization Dialog Box
is displayed.
Confirm that the data to transfer
(NJ501 in the right dialog box) is
selected. Then, click the
Transfer To Controller Button.
*After executing Transfer To
Controller, the Sysmac Studio
data is transferred to the
Controller and the data are
compared.
11
A confirmation dialog box is
displayed. Confirm that there is
no problem and click the Yes
Button.
A screen stating "Synchronizing"
is displayed.
A confirmation dialog box is
displayed. Confirm that there is
no problem and click the No
Button.
*Be sure not to return it to "RUN
mode".
To Next Page
Loading...
