Omron CJ2H-CPU6*-EIP Series - Page 19

7
．
EtherNet/IP Connection Procedure
16
7.2.2. Parameter Settings
Set the parameters for Sensor Controller.
1
Check the positions of each key
and displays to use for
parameter settings.
2
Turn ON Sensor Controller.
3
The system enters the RUN
mode after displaying “INIT” for
a few seconds.
*The RUN Indicator is lit in the
RUN mode.
Press and hold the Mode
Switching Key for two seconds.
*5000
THRESHOLD H L RUN
4
OK/CAN is displayed.
Press the ZERO/SET Key.
0kzcan
Main Display (White)
Sub-display (Green)
RUN Indicator (Green)
ZERORST/ESC Key
ZERO/SET Key
↓
(DOWN) Key
↑(UP) Key
→
(RIGHT) Key
←
(LEFT) Key
Mode Switching
Key