6-5
6 Troubleshooting
CP1E CPU Unit Hardware User’s Manual(W479)
6-1 Troubleshooting CPU Unit Errors
6
6-1-5 Types of Errors
z Directly Monitoring the Area where Error Log Information is Stored
1
Connect the CX-Programmer online.
2
Read words A100 to A199.
3
Check the error status from the registered data.
The type of error that has occurred can be identified by checking the indicators on the front of the CPU
Unit, or by using the CX-Programmer to check the error status.
The errors detected by the CPU Unit are listed in the following table.
Refer to 6-2 Troubleshooting Unit Errors for errors not detected by the CPU Unit.
: Not lit : Flashing : Lit
6-1-5 Types of Errors
• Error code storage word: The error code is stored in A400 when an error occurs.
• Error flags: Flags that indicate the type of error are allocated in the Auxiliary Area.
• Error information: There are words in the Auxiliary Area that provide specific information
on the meaning of error flags and information on the error location and
error details.
Error
POWER
RUN
ERR/
ALM
INH PRPHL BKUP
Built-in
RS-232C/
RS-485
communi-
cations
status
Error
code
(in A400)
Error
flag
Error
information
Opera-
tion
status
Error Word
Power supply error
Not lit Not lit Not lit Not lit Not lit
−
Not lit
−−−−
Opera-
tion
stops.
CPU error (WDT
error)*1
Lit
Not lit
Lit
−−− − − − − −
Opera-
tion
stops.
Peripheral USB port
communications
error
Lit Lit
Not lit
−
Not lit
−− − −−−
Opera-
tion con-
tinues.
Built-in RS-232C
port/Built-in RS-485
port communica-
tions error
Lit Lit
Not lit
−−−
Not lit
−−−−
Opera-
tion con-
tinues.
Fatal
errors
*1*2
Memory
error
Lit
Not lit
Lit
−−− −0x80F1 A401.15 Memory
Error
Location
A403 Opera-
tion
stops.
I/O bus error 0x80CA A401.14 Always
0x0A0A
A404
Too many
I/O points
error
0x80E1 A401.11 Always
0x4000
A407
Program
error
0x80F0 A401.09 Program
Error
Details
A294
to
A299
Cycle time
exceeded
error
0x809F A401.08 −−
FALS error
0xC101 to
0xC2FF
A401.06 −−
To Next Page
Loading...
Need help?
General
