E3X-DA-N
Amplifier Adjustments
All Models
Changing the Display (RUN Mode)
Manual Tuning (Fine Sensitivity Adjustment) in ADJ Mode
1 Zero-reset (RUN Mode)2
Initial Reset (SET Mode)3
The items displayed in ADJ mode vary with the display
setting in R
UN mode.
Cancel Execute initial reset
Perform fine sensitivity adjustment after teaching and
manual tuning (without using the teaching function) in
the way shown below:
1 s
1 s
2 s
2 s
2 s
Hold down
both for 3 s.
Hold down
both for 5 s.
Digital incident level (4000 max.)
To reset to zero again:
*
*There is no limit on the number of times zero-reset can be used.
To return the initial digital incident level:
Set the mode
selector to RUN.
(Factory-set to RUN)
Set the mode
selector to SET.
Set the mode
selector to ADJ.
Fine sensitivity adjustment
RUN mode
Digital incident level
Digital percent
Analog value
ADJ mode
Digital threshold
Digital percent
Analog value
Digital incident level (4000 max.)
Digital percent
Analog incident level and threshold
First, select the channel to be
adjusted using the channel
selection switch.
Twin-output Models
Set the mode
selector to RUN.
Sensitivity
increment with
threshold
decrement
Sensitivity
decrement
with threshold
increment
TEACH MODE
TEACH
MODE MODE
TEACH MODE
TEACH
TEACH
RUN
RUN
ADJ
TEACH MODE
MODE
MODE
MODE
SET
CH1 CH2
http://www.ia.omron.com/
19
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
To Next Page
Loading...
