E3X-DA-NE3X-DA-N
34
Special-purpose diffuse fibers – continued from previous page
: Long-distance mode : Standard mode
: High-speed mode
D “Standard object” measurements were made with E3X-DA-N set to Standard mode.
D “Minimum sensing object” is shown in parentheses below the standard object. The values of the minimum sensing object were
obtained at a distance where the smallest object (gold wire) can be sensed with the Diffuse Fiber Unit.
D The E3X-DA-N may continue to receive internal reflective light when it is set to the maximum sensitivity setting. In this case, set the
amplifier to “two-point teaching with or without-object teaching.”
Indicates models that customers can cut to length for their application. Models without this mark are pre-cut by the factory to maintain
their respective specifications.
Applica-
tion
Features Appearance Applicable
amplifier unit
Sensing distance (mm)
(Values measured
using white paper)
Standard
object
(min.
sensing
object)
Part number Permis-
sible
bend-
ing
radius
Area
sensing
Side-view; detec-
tion over wide
areas
E3X-DAj-N
200
150
50
300 300
mm
(0.01-mm
dia.)
E32-D36P1 25 mm
Conver-
gent
beam
Suitable for posi-
tioning crystal
glass
E3X-DAj-N
4 to 12
100 100
mm
Soda
glass with
reflection
factor of
7%
E32-L56E1
E32-L56E2
35 mm
Detects wafers and
small differences in
height;
Operating ambient
_
E3X-DAj-N
4±2
4±2
4±2
25 25
mm
(0.01-mm
dia.)
E32-L24L
10 mm
temperature: –40_C
to 105_C
(–40_F to 221_F);
enclosure rating:
IP50
E3X-DAj-N
7.2±1.8
7.2±1.8
7.2±1.8
E32-L25L
Detects wafers and
small differences in
height; enclosure
E3X-DAj-N
3.3
3.3
3.3
E32-L25
25 mm
rating: IP50
E3X-DAj-N
3.3
3.3
3.3
E32-L25A
Fluid-
level
detection
Fluid contact type:
unbendable section
L 150 mm, 350 mm
(two types)
E3X-DAj-N
--- Pure
water at
25_C
E32-D82F1
E32-D82F2
40 mm
Tube-mounting
type
E3X-DAj-N
--- Fluid E32-L25T 10 mm
To Next Page
Loading...
