Omron E3X-DA-N - Special-Purpose Through-Beam Fibers

E3X-DA-NE3X-DA-N
28
J SPECIAL-PURPOSE THROUGH-BEAM FIBERS
: Long-distance mode : Standard mode
: High-speed mode
D “Standard object” measurements were made with E3X-DA-N set to Standard mode. The size of standard object is the same as the
fiber core diameter or the lens diameter for models with a lens.
D “Minimum sensing object” is shown in parentheses below the standard object. The minimum sensing object size was determined
when the E3X-DA-N amplifier received light that exceeded a light incident value of 1000 (set to digital incident level display).
Indicates models that customers can cut to length for their application. Models without this mark are pre-cut by the factory to maintain
their respective specifications.
Applica-
tion
Feature Appearance Applicable
amplifier unit
Sensing distance (mm)
(Values in parentheses
when using the E39-F1
Lens Kit)
Standard
object
(Minimum
sensing
object:
opaque)
Part
number
Permis-
sible
bend-
ing
radius
Chemi-
cal
resistant
Teflon-covered
*1; withstands
chemicals and
harsh environ-
ments;
Operating ambi-
ent temperature:
–30_C to 70_C
(–22_F to 158_F)
5-mm dia.
E3X-DAj-N
3,800
3,000
1,100
4.0-mm
dia.
(0.01-mm
dia.)
E32-T12F
40 mm
Side view Teflon-
covered *1; with-
stands chemicals
and harsh envi-
ronments;
Operating ambi-
ent temperature:
–30_C to 70_C
(–22_F to 158_F)
5-mm dia.
E3X-DAj-N
500
150
400
3.0-mm
dia.
(0.01-mm
dia.)
E32-T14F
Heat-
resistant
Resists 200°C;
flexible (R10);
fiber sheath mate-
rial: Teflon *1;
Operating ambi-
ent temperature:
–40_C to 200_C
(–40_F to 392_F)
M4 screw
E3X-DAj-N
280
100
350
1.0-mm
dia.
(0.01-mm
dia.)
E32-T61R 10 mm
Resists 150°C *2;
fiber sheath mate-
rial: fluororesin;
Operating ambi-
ent temperature:
–40_C to 150_C
(–40_C to 302_F)
M4 screw
E3X-DAj-N
950
760
280
1.5-mm
dia.
(0.01-mm
dia.)
E32-T51 35 mm
Resists 300°C *3,
with spiral tube;
high mechanical
strength; fiber
sheath material:
stainless steel;
Operating ambi-
ent temperature:
–40_C to 300_C
(–40_F to 572_F)
M4 screw
E3X-DAj-N
450 (3,400)
170 (1,300)
570 (4,000)
(See Note 4)
1.0-mm
dia.
(0.01-mm
dia.)
E32-T61 25 mm
Note: 1. Teflon is a registered trademark of the Dupont Company and the Mitsui Dupont Chemical Company for their fluoride resin.
2. For continuous operation, use the products within the temperature ranging from –40°C to 130°C (–40°F to 266°F).
3. Indicates the heat-resistant temperature at the fiber tip
4. This model allows a longer sensing distance in Long-distance mode because the optical fiber length is 2 m.