6 Parameters
6 - 10
E5@C-T Digital Temperature Controllers User’s Manual (H185)
prg
Program No.
• This parameter specifies the program number to use to start program operation.
• This parameter can be used only when resetting and only when the Event Input
Assignment 1 to 6 parameters are not set to switch the program number.
z Related Parameters
Run/Reset (Operation Level): Page 6-14
hold
Hold
The Event Input Assignment 1 to 6 parameters
must not be set to Hold or Hold Clear, the
Run/Reset parameter must be set to Run, operation
must not be on standby, and program operation
must not be continuing after the completion of
operation.
• This parameter is used to hold the timer for program operation.
• Use the run operation, reset operation, or hold clear command to clear hold status.
The timing operation is held when the parameter is set to on.
The default is off (clear hold).
z Related Sections
5-15 Program-related Functions (page 5-53)
seg
Segment No.
The Run/Reset parameter must be set to Run,
operation must not be on standby, and program
operation must not be continuing after the
completion of operation.
This parameter is used to move the program to the beginning of a specified segment (i.e., to
jump to a segment). If you jump during hold status, the hold status will be continued at the
beginning of the specified segment.
This parameter monitors the segment number that is being executed in the program before
and after editing.
z Related Sections
5-15 Program-related Functions (page 5-53)
Function
Setting
Setting range Unit Default
0 to 7 --- 0
See
See
Function
Operation
See
See
Function
Monitor
See
See
To Next Page
Loading...
Need help?
General
