Omron E5AC-T User Manual

6 - 75
6 Parameters
E5@C-T Digital Temperature Controllers User’s Manual (H185)
6-9 Initial Setting Level
6
*1 This function can be set for heating/cooling control or for floating control for
Position-proportional Models, but the setting will be disabled.
*2 This function can be set only for a Controller that supports communications. Also, if a work bit is
selected as the event input data, you cannot select communications writing enable/disable.
clfl
Close/Floating A Position-proportional Model must be used.
• The Close/Floating parameter is used to set the control method for a
Position-proportional Model.
Setting
Setting Function
none None
rr-1 Run (OFF)/Reset (ON)
rr-2 Run (ON)/ Reset (OFF)
manu Auto/Manual
rst Reset
run Run
hld1 Hold/Clear Hold
hld2 Hold
adv Advance
prg0 Program Number Switch 0
prg1 Program Number Switch 1
prg2 Program Number Switch 2
drs Direct/Reverse Operation
spm Program SP Mode/Fixed SP Mode
at-2 100% AT Execute/Cancel
at-1
40% AT Execute/Cancel
*1
ata2 All PID 100% AT Execute/Cancel
ata1
All PID 40% AT Execute/Cancel
*1
wtpt Setting Change Enable/Disable
cmwt
Communications Writing Enable/Disable
*2
lat Alarm Latch Cancel
wait Wait Enable (ON)/Disable (OFF)
Function
Setting
Setting range Default
flot: Floating control
clos: Close control
flot

Omron E5AC-T Specifications

General

Brand	Omron
Model	E5AC-T
Category	Temperature Controller
Language	English