Omron fh series Hardware Setup Manual

Precautions for Correct Use
Turning OFF the Power
When a message is displayed indicating that a task is in progress, do not turn OFF the power
.
Doing so causes the data in the memory to be corrupted, resulting in the product not operating
properly upon the next start-up.
Do not turn OFF during saving data to Sensor Controller.
When turns OFF, conform the followings proceedings have completed. and then operate again.
- When saves using Sensor Controller: Confirm the save processing is completed and next op-
eration is possible.
- When saves using communication command: Intended command is completed. BUSY signal
is turned OFF.
Maintenance
Turn OFF the power and ensure the safety before maintenance.
5 Setup and Wiring
5-3
FH Series Vision System Hardware Setup Manual for 3D Robot Vision (Z436-E1)
5-1 When turning ON and OFF
5
5-1-1 FH-5050

Omron fh series Specifications

General

Type	Machine Vision System
Series	FH Series
Power Supply	24 VDC
Storage Temperature	-20 to 60°C
Humidity	35 to 85% RH (non-condensing)
Image Sensor	CMOS
Processing Speed	High-speed processing
Connectivity	Ethernet
I/O	Digital I/O
Operating System	Embedded OS
I/O Ports	Ethernet, USB