Omron FQ2-S Series User Manual

Control Methods Using an External Device
FQ2-S/CH User’s Manual
for Communications Settings
27
1
Overview of Communication Specifications
PLC Link
The output data that is assigned is output to the output area as shown below.
Any output data that exceeds the set value of the [Max output data] (number of output data upper value)
parameter setting (e.g., 256 bytes) is discarded.
For the [Max output data] setting, refer to Initial Settings for PLC Link Communications on page 122.
+0
Output data Assigned output data
+1
Output data 0
(4 bytes)
Output data 1
(4 bytes)
Output data 2
(4 bytes)
Output data 31
(4 bytes)
Output data 32
(4 bytes)
Output data 61
(4 bytes)
Output data 62
(4 bytes)
Output data 63
(4 bytes)
Output data 64
(4 bytes)
Output data 65
(4 bytes)
Output data 66
(4 bytes)
Inspection item 0: Position X for Search
+2
+3
Inspection item 0: Position Y for Search
+4
+5
Inspection item 1: Position X 1st point for Shape Search II
+62
+63
Inspection item 1: Position X 30th point for Shape Search II
+64
+65
Inspection item 1: Position Y 1st point for Shape Search II
+122
+123
Inspection item 1: Position Y 30th point for Shape Search II
+124
+125
Inspection item 2: Position X 1st point for Shape Search II
+126
+127
Inspection item 2: Position Y 1st point for Shape Search II
+128
+129
Inspection item 2: Position X 2nd point for Shape Search II
+160
+161
Inspection item 2: Position X 10th point for Shape Search II
+162
+163
Inspection item 2: Position Y 10th point for Shape Search II
Offset from first
address in output area
256 bytes
(Data that is
output the
first cycle.)
72 bytes
(The data that
exceeds the
set upper limit
is discarded.)
FQ2-S_CH_comm.book 27 ページ ２０１４年６月２６日 木曜日 午前１１時４７分

Omron FQ2-S Series Specifications

General

Brand	Omron
Model	FQ2-S Series
Category	Security Camera
Language	English