Omron FQ2-S Series - Page 309

Command Control
FQ2-S/CH User’s Manual
for Communications Settings
307
5
Appendices
DOPORTCOND or DPC
Batch Set D Terminal Statuses
Batch sets the ON/OFF status for the D terminals (D0 to D15).
Before executing this command, change the FQ2 execution mode to stop mode with the Set Execution Mode com-
mand.
Set Execution Mode: p.321
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
Important
DOP OR T C O N D CR
C
Terminal status
(5 digits max.)
Command
Space
(0x20)
Delimiter
Delimiter
Command
or
PD
Terminal status
(5 digits max.)
CR
Space
(0x20)
Delimiter
CR OK
CR ER
Delimiter
FQ2-S_CH_comm.book 307 ページ ２０１４年６月２６日 木曜日 午前１１時４７分