Omron FQ2-S Series - Page 327

Command Control
FQ2-S/CH User’s Manual
for Communications Settings
325
5
Appendices
PARAPORTCOND or PPC
Set Terminal Status
This command sets the output signal ON/OFF status for the specified parallel I/O terminal.
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
PA P OR T C ON D CR R
C
A
Terminal type
(2 digits max.)
Terminal number
(2 digits max.)
Terminal status
(1 digit max.)
Command
Space
(0x20)
Space
(0x20)
Space
(0x20)
Space
(0x20)
Space
(0x20)
Delimiter
Delimiter
Command
or
PP
Terminal type
(2 digits max.)
Terminal number
(2 digits max.)
Terminal status
(1 digit max.)
CR
Space
(0x20)
Delimiter
CR OK
CR ER
Delimiter
FQ2-S_CH_comm.book 325 ページ ２０１４年６月２６日 木曜日 午前１１時４７分