Omron FQ2-S Series - Page 329

Command Control
FQ2-S/CH User’s Manual
for Communications Settings
327
5
Appendices
POSITIONDATA or PD
Set Image Adjustment Data
This command sets parameters from a position compensation item or filter item.
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
<Parameter Descriptions>
Inspection item number Specifies the item number of the position compensation item or of the filter item.
External reference data
number
Specifies the external reference data number.
Section 9-2 External Reference Parameters
in Vision Sensor FQ2-S/CH Series User's Manual (Cat. No. Z337)
Setting value Specifies the set value.
Section 9-2 External Reference Parameters
in Vision Sensor FQ2-S/CH Series User's Manual (Cat. No. Z337)
PO ON DAT A CR SI IT
External reference data
(4 digits max.)
Setting value
Command
Space
(0x20)
Space
(0x20)
Delimiter
Item
number
Space
(0x20)
Space
(0x20)
Command
or
DP
Setting value
CR
Delimiter
Space
(0x20)
Space
(0x20)
External
reference data
(4 digits max.)
Space
(0x20)
Space
(0x20)
Item
number
CR OK
Delimiter
CR ER
Delimiter
FQ2-S_CH_comm.book 327 ページ ２０１４年６月２６日 木曜日 午前１１時４７分