23
8.General Preparation
EN
8.5. Loading Printer Paper
1. Press the release button at the top of the main unit to open the printer cover.
[Figs. 8 and 9]
2. Load the specially designed printer paper into the holder in the direction shown in the
diagram. [Fig. 10]
3. With a small amount of paper sticking out, push the cover closed until it locks into place.
[Fig. 11]
[Fig. 9]
[Fig. 8]
Load the printer paper as shown in the diagram.
* Pull out the paper so that it protrudes from the
printer cover when closing.
When loading a new roll of paper, pull the end out
about 25 cm (10 inches). The end of the roll is sealed
with glue, which does not make a suitable printing
surface.
* Make sure you use OMRON printer paper, refer to Section 5.2.
[Fig. 10]
* When the power is on, the paper will
automatically advance and cut.
[Fig. 11]
Printed side up
To Next Page
Loading...
