58 LD Cart Transporter User's Manual 14766-000 Rev H
3.5 Installing the Cart Brake Release
Figure 3-22. Brake-release Lever
CAUTION: PERSONALINJURYRISK
It is important that the brake-release handle be mounted in an ergonomically-
suitable location, so an Operator can repetitively release the brakes without risk-
ing injury.
The actual mounting location and procedure for the brake-release handle are not covered here
due to the variability that is possible in cart structure designs. Ensure that no part of the cart
brake-release cable bends more than a 76 mm (3 inches) radius.
There is a 6.4 mm (0.25 inch) horizontal hole through the rear horizontal tube of the cart. See
the following two figures.
To Next Page
Loading...
