134
Outline of Programming Section 8-1
8-1 Outline of Programming
8-1-1 Outline
The NE1A-series Safety Network Controller is programmed by starting a
Logic Editor from the Network Configurator. As shown below, the Logic Editor
consists of a Function List where function blocks, I/O tags, and other program-
ming elements are registered and a workspace where programming is actu-
ally performed.
Programming is achieved using the function blocks, I/O tags, and other pro-
gramming elements are registered in the function list.
8-1-2 Programming Basics
Programs are created from logic functions and function blocks, which indicate
commands, input tags, which indicate data input sources, and output tags,
which indicate data output destinations. The I/O are connected with connec-
tion lines.
Function List
Workspace
Input tags
Output tags
Function blocks
To Next Page
Loading...
