173
Command Reference: Function Blocks Section 8-5
Timing Chart
8-5-8 ON-delay Timer
Diagram
General Description
The ON-delay Timer function block performs a timer operation for an ON
delay set in 10-ms increments. The range for this delay is from 0 ms to 300 s.
Set Parameters
The delay time must be equal to or greater than the NE1A-series Controller’s
cycle time.
Timing Chart
Input
Output
Enable
Set Value
Timer Value
0
Idle to RUN
Parameter Setting range Default setting
Delay Time 0 to 300 s in 10-ms increments 0 ms
Input
Output
Enable
Set value
T imer value
0
Idle to RUN
To Next Page
Loading...
