17
System Setup Procedure Section 1-3
1-3 System Setup Procedure
The general working phases until the Safety System is operational are shown
below.
The NE1A-series Controller information required in each phase is described
in the following sections.
Refer to the following manuals for information on DeviceNet and EtherNet/IP
installation, DeviceNet Safety System construction, Network Configurator
operation, Programming Device operation, and other devices used in the
safety system.
1. System Design
2. Programming
4. Configuration
3. Installation and Wiring
5. User Testing
6. System Operation
Working phase Required information Details
System design • System overview and example configurations
• Specifications and functions
• Performance
Section 1
Section 2, Section 4 to 10
Section 11
Programming • Programming guidelines
• Function block specifications
Section 8
Installation and wiring • Node address and baud rate settings
• Installation location
• Device connections
• Power supply wiring
• Connection with I/O devices
• Wiring for DeviceNet
• EtherNet/IP wiring
Section 4-1
Section 3
Configuration • Configuration method Section 9
User test • Error classification and error history Section 12
System operation • Maintenance and inspection Section 13
Item Manual name Cat. No.
Installation of DeviceNet DeviceNet User’s Manual W379
Installation of EtherNet/IP NE1A-series DeviceNet Safety Network Control-
ler Operation Manual
Z906-E1-07
or higher
To Next Page
Loading...
