Omron NE1A-SCPU01 - 07-2009 - Function Block Editing; Function Block Parameter Settings

138
Function Block Editing Section 8-3
8-3 Function Block Editing
Editing of function blocks can be used to set parameters, add optional I/O,
and add comments according to the application.
8-3-1 Function Block Parameter Settings
The following parameters can be set for function blocks depending on the
user application. The parameters that can be set will vary from function block
to function block.
• Input type
• Discrepancy time
• Synchronization time
• Function test
Input Type Settings
• Single Channel
• Dual Channel Equivalent
• Dual Channel Complementary
• Dual Channel Equivalent (2 Pairs)
• Dual Channel Complementary (2 Pairs)
The following truth tables outline the internal evaluations performed by the
NE1A-series Controller for each type of input signal. In the tables, 0 indicates
OFF and 1 indicates ON.
Setting: Single Channel
Setting: Dual Channel Equivalent
Tabs:
Function block parameters
Out point Setting, In/Out
Settings Comments
Input 1
(NC)
Output
Enable
00
11
Input 1
(NC)
Input 2
(NC)
Output
Enable
000
010
100
111