158
Command Reference: Function Blocks Section 8-5
Number of Inputs Setting
The number of inputs can be increased on the In/Out Setting Tab Page in the
function block property dialog box.
Optional Output Settings
The outputs shown below can be used in the program. To enable either of
these outputs, select the checkbox on the Out Point Tab Page of the function
block properties dialog box.
• Static Release
• Restart Required Indication
Low-High-Low Rising Edge
Monitored
Input
Reset
Output
Enable
350 ms min.
Monitored
Input
Reset
Output
Enable
Parameter Setting range Default setting
Number of inputs 2 to 8 (Optional Input Settings) 2
To Next Page
Loading...
