xxviii
Unit Versions of NE1A-series Controllers 7
Unit Versions and Programming Devices
Network Configurator version 2.0@ or higher must be used when using a
NE1A-SCPU01-V1 or NE1A-SCPU02 Safety Logic Controller with unit ver-
sion 2.0.
Network Configurator version 2.2@ or higher must be used when using a CPU
Unit that supports EtherNet/IP.
The following table shows the relationship between unit versions and Network
Configurator versions.
Note (1) Can be used as a Controller with unit version 1.0.
(2) Network Configurator version 1.5@ or lower can be upgraded to version
1.6@ free of charge.
(3) When using Network Configurator version 1.6@, there are no operational
differences in the NE1A-SCPU01-V1 and NE1A-SCPU02 Safety Logic
Controllers that derive from the unit version.
Unit Versions and Configuration Data
The following table shows the relationship between unit versions of NE1A-
series Controllers in Network configuration files created with Network Config-
urator version 2.2@ and the unit version of NE1A-series Controllers to which
configuration files are downloaded.
Note (1) Downloading is possible if the device type is changed using the function
provided in Network Configurator version 2.2@. For details, refer to
NE1A-series Controller Upgrade Procedure on page xxix.
(2) Only functions CPU Units with unit version 1.0 can be used.
Model number Network Configurator
Ver. 1.3@ Ver. 1.5@ Ver. 1.6@ Ver. 2.0@/2.1@ Ver. 2.2@
NE1A-SCPU01
Pre-Ver. 1.0
Can be used. Can be used. Can be used. Can be used. Can be used.
NE1A-SCPU01-V1 with unit
version 1.0
Cannot be used. Cannot be used. Can be used. Can be used. Can be used.
NE1A-SCPU02 with unit ver-
sion 1.0
Cannot be used. Cannot be used. Can be used. Can be used. Can be used.
NE1A-SCPU01-V1 with unit
version 2.0
Cannot be used. Cannot be used. Can be used.
(See note 1.)
Can be used. Can be used.
NE1A-SCPU02 with unit ver-
sion 2.0
Cannot be used. Cannot be used. Can be used.
(See note 1.)
Can be used. Can be used.
NE1A-SCPU01-EIP Cannot be used. Cannot be used. Cannot be used. Cannot be used. Can be used.
NE1A-SCPU02-EIP Cannot be used. Cannot be used. Cannot be used. Cannot be used. Can be used.
Unit versions of NE1A-series
CPU Unit in Network
configuration files created
with Network Configurator
version 2.2@
NE1A-series CPU Unit to which configuration file is downloaded
Pre-Ver. 1.0 CPU
Unit
CPU Unit with unit
version 1.0 that
does not support
EtherNet/IP
CPU Unit with unit
version 2.0
CPU Unit with unit
version 1.0 that
supports EtherNet/
IP
Pre-Ver. 1.0 CPU Unit Downloading is pos-
sible.
Not possible.
(See note 1.)
Not possible.
(See note 1.)
Not possible.
(See note 1.)
CPU Unit with unit version 1.0
that does not support Ether-
Net/IP
Not possible. Downloading is pos-
sible.
Downloading is pos-
sible. (See note 2.)
Not possible.
(See note 1.)
CPU Unit with unit version 2.0 Not possible. Not possible. Downloading is pos-
sible.
Not possible.
(See note 1.)
CPU Unit with unit version 1.0
that supports EtherNet/IP
Not possible. Not possible. Not possible. Downloading is pos-
sible.
To Next Page
Loading...
