1-5
Software
This section describes an overview of each software in the system configuration.
Use the Sysmac Studio as a development environment for the robot integrated system.
1-5-1
Sysmac Studio
The Sysmac Studio provides development environment for a robot integrated system on a computer.
Precautions for Correct Use
For a robot integrated system, use the 64-bit edition DVD (SYSMAC-SE200D-64) with the Sys-
mac Studio version 1.££. You cannot use the 32-bit edition DVD (SYSMAC-SE200D).
The Sysmac Studio has the following functions.
Function Description
Robot control
function
A function to make settings and create a program to control a robot with the Robot Integrat-
ed CPU Unit and IPC Application Controller. T
o use this function, you need a license for the
Standard Edition (SYSMAC-SE2££L).
3D simulation
function
A function to perform a 3D simulation including robots and peripheral devices. To use this
function, you need a license with the 3D Simulation Option (SYSMAC-SA4££L-64).
Refer to the Sysmac Studio Robot Integrated System Building Function with Robot Integrated CPU
Unit Operation Manual (Cat. No. W595) for information on the robot control function in the Sysmac
Studio and the Sysmac Studio 3D Simulation Function Operation Manual (Cat. No. W618) for informa-
tion on the 3D simulation function.
Additional Information
Refer to A-2 Setting Items on the Sysmac Studio and the Setting Targets
on page A-21 for in-
formation on which hardware setting corresponds to the items on the Multiview Explorer of the
Sysmac Studio.
1 Overview
1-8
NJ-series Robot Integrated System Startup Guide (O049)
To Next Page
Loading...
Need help?
General
