EasyManuals Logo

Omron NJ Series Startup Guide

Omron NJ Series
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
2-1
Installing the Sysmac Studio
The Sysmac Studio Ver.1.££ 64-bit edition DVD (SYSMAC-SE200D-64) is the Support Software that
you use for the Robot Integrated System. On it, you can set up the configurations and parameters, you
can create programs, and you can debug and simulate operation.
1 Set the Sysmac Studio installation disk into the DVD-ROM drive.
The setup program is started automatically and the Select Setup Language Dialog Box is dis-
played.
2 Select the language to use, and then click the OK button.
The Sysmac Studio Setup Wizard is started.
3 Follow the instructions given by the Setup Wizard to complete the installation.
4 Restart the computer when the installation is completed.
Additional Information
Refer to the Sysmac Studio Robot Integrated System Building Function with Robot Integrated
CPU Unit Operation Manual (Cat. No. W595) for information on the system requirements for
the computer to which you install the Sysmac Studio.
Refer to the
Sysmac Studio Version 1 Operation Manual (Cat. No. W504) if you are unable to
install the Sysmac Studio with the above instructions.
2 Before You Begin
2-2
NJ-series Robot Integrated System Startup Guide (O049)

Table of Contents

Other manuals for Omron NJ Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron NJ Series and is the answer not in the manual?

Omron NJ Series Specifications

General IconGeneral
Program CapacityUp to 128 MB
SD Card SlotYes
Power Supply Voltage24 VDC
Motion ControlYes
USB Ports1
Operating Temperature0°C to 55°C
Communication InterfacesEthernet/IP, EtherCAT, USB
Safety FunctionOptional
Storage Temperature-20°C to 75°C
Communication PortsUSB
DimensionsVaries by model
WeightVaries by model

Related product manuals