Omron NJ Series

2 Click the Pull from V+ Memory icon in the toolbar of the Multiview Explorer.
3 Select Configurations and Setup - Save Configuration in the Multiview Explorer.
4 Click the Save T
o Controller
button in the Save Configuration tab page.
5 Click File - Save from the menu bar.
3-4-4
Executing Program to Check Operation
The robot operation before the automatic operation is checked according to the program.
1 Change the operating mode switch on the front panel to Auto Mode.
3 Implementation Example of Static Pick-and-place Equipment
3-91
NJ-series Robot Integrated System Startup Guide (O049)
3-4 Setup Procedure for Actual System
3
3-4-4 Executing Program to Check Operation