Omron NJ Series

In the tree of the Multiview Explorer, program0 - program0 are added under V+ Modules,
which allows you to edit the name of the V+ program.
3 Enter the name of the V+ program.
The name of the V+ program is changed.
4 Double-click the program to edit.
A tab page to edit the V+ program is displayed in the Edit Pane.
3 Implementation Example of Static Pick-and-place Equipment
3-33
NJ-series Robot Integrated System Startup Guide (O049)
3-3 Programming and Simulation Procedures
3
3-3-4 Creating V+ Programs