102
A-3-7 NQ with Siemens S7 (MPI) Driver and Siemens S7-300
Series PLC
To perform a successful communication proceed as follows.
Note that only 1 to 1 connection is supported from NQ-Series.
1 Right-click the Nodes folder and click Add....
2 Set all data as shown in the screenshot.
3 Create PLC tag with address MW0000.
4Add a Data Entry object with tag address MW0000 on screen1.
5 Download the application and firmware to the NQ-Series.
6 Open SIMATIC Manager.
7Click Properties on File menu.
8 Set all data as shown in the screenshot.
9 Download the application to the PLC.
To Next Page
Loading...
