101
8 Set all data as shown in the screenshot.
9 Download the application to the PLC.
10 Click Status chart in project window and enter MW0000 in the screen. Monitor the values in the field.
11 Connect the cable to the NQ-Series and PLC. Refer to A-4-4 NQ to Siemens S7-200 Series. Connect the
PLC end port to the Siemens S7-200 PLC. Connect the NQ-Series’ male port of the cable to the defined
COM1 port of the NQ-Series.
12 Enter 10 on the NQ-Series’ screen. If the connection has been correctly established the same value is
shown in Step 7 MICRO/WIN Siemens software.
Note
The following messages are displayed on the NQ-Series’ screen if problems occur:
• !!! no connection
• ??? connection established, address unknown
To Next Page
Loading...
