Omron S8M - Page 87

69
Special Settings and Communications Settings Section 4-8
Stop Bit Setting: BIT (Stop Bits)
The stop bit setting display (BIT) will be displayed if the Down Key ( ) is
pressed from the data length setting display (LEN).
(
Return to LEN dis
p
la
y
.
)
When the Key is pressed, the setting will flash. When the
flashing stops, the new setting will be saved and the S8M will
return to the LEN display. If you want to confirm the new set-
ting, press the Key again from the LEN display.
If the Down Key ( ) is pressed from the LEN display, the dis-
play will switch to the stop bit setting display (BIT).
b i t
2
1
(Return to "BIT" display.)
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
23
4
°C
kh
V
A
s
1
This parameter sets the number of stop bits to 1 bit or 2 bits.
Switch to the
parity setting.
Press the Key to display the stop bit setting.
The setting can be changed by pressing t
he or
Key.
1: 1 bit
2: 2 bits
Change the setting with the or Key.
The S8M will automatically return to the “BIT” dis-
play if no key is pressed within 3 s.
When the Key is pressed, the setting will flash.
When the flashing stops, the new setting will be
saved and the S8M will return to the “BIT” display.
If you want to confirm the new setting, press the
Key again from the “BIT” display.
If the Down Key ( ) is pressed from the “BIT” display, the
display will switch to the parity setting display (PTY).