Omron SYSMAC CS1W-SCB41-V1 - P V600;V620 ID Controller Protocol

689
Appendix P
V600/V620 ID Controller Protocol
The V600/V620 ID Controller Protocol is used to make various settings or control remotely the ID Controller
Connected to the Serial Communications Unit/Board via RS-232C or RS-422 cable.
Protocol Configuration
The configuration of the V600/V620 ID Controller Protocol is shown below.
Sequence
No.
Communications
sequence name
Function Ladder interface
Send word
allocation
Receive word
allocation
500 (01F4) Read (ASCII/1) Used when the number of Heads to be read
from the Carrier is 1.
Ye s Ye s
501 (01F5) Read (ASCII/2) Used when the number of Heads to be read
from the Carrier is 2.
Ye s Ye s
502 (01F6) Read (ASCII/4) Used when the maximum number of Heads to
be read from the Carrier is 4.
Ye s Ye s
503 (01F7) Read (ASCII/8) Used when the maximum number of Heads to
be read from the Carrier is 8.
Ye s Ye s
504 (01F8) Read (Hex/1) Used when the number of Heads to be read
from the Carrier is 1.
Ye s Ye s
505 (01F9) Read (Hex/2) Used when the number of Heads to be read
from the Carrier is 2.
Ye s Ye s
506 (01FA) Read (Hex/4) Used when the maximum number of Heads to
be read from the Carrier is 4.
Ye s Ye s
507 (01FB) Read (Hex/8) Used when the maximum number of Heads to
be read from the Carrier is 8.
Ye s Ye s
508 (01FC) Auto-read (ASCII/1) Used when the number of Heads to be read
from the Carrier is 1.
Ye s Ye s
509 (01FD) Auto-read (Hex/1) Used when the number of Heads to be read
from the Carrier is 1.
Ye s Ye s
510 (01FE) Polling Auto-read
(ASCII)
Used when the number of Heads to be read
from the Carrier is from 1 to 8.
Ye s N o
511 (01FF) Polling Auto-read
Subcommand
(ASCII/2)
Used when the number of Heads to be read
from the Carrier is 2.
Ye s Ye s
512 (0200) Polling Auto-read
Subcommand
(ASCII/4)
Used when the maximum number of Heads to
be read from the Carrier is 4.
Ye s Ye s
513 (0201) Polling Auto-read
Subcommand
(ASCII/8)
Used when the maximum number of Heads to
be read from the Carrier is 8.
Ye s Ye s
514 (0202) Polling Auto-read
(Hex)
Used when the number of Heads to be read
from the Carrier is from 1 to 8.
Ye s N o
515 (0203) Polling Auto-read
Subcommand (Hex/2)
Used when the number of Heads to be read
from the Carrier is 2.
Ye s Ye s
516 (0204) Polling Auto-read
Subcommand (Hex/4)
Used when the maximum number of Heads to
be read from the Carrier is 4.
Ye s Ye s
517 (0205) Polling Auto-read
Subcommand (Hex/8)
Used when the maximum number of Heads to
be read from the Carrier is 8.
Ye s Ye s
518 (0206) Write (ASCII/1) Used when the number of Heads to be written
to the Carrier is 1.
Ye s N o