5 Start Up
I67E-EN V1000 Quick Start Guide 19
ENGLISH
For Auto-Tuning enter the Auto-Tuning menu and perform the steps shown in the figure
below. The number of name plate data to be entered depends on the selected type of Auto-
Tuning. This example shows Rotational Auto-Tuning.
If Auto-Tuning can not be performed for some reason (no-load operation impossible etc.),
then set up the maximum frequency and voltage in the E1- parameters and enter the
motor data manually into the E2- parameters.
NOTICE! The Safe Disable inputs must be closed during Auto-Tuning.
Enter the Auto-
Tuning Mode
Select the tuning
method
Set up all name
plate data
The tuning start
display appears
During the tuning the
DRV LED flashes
After successful tuning
“End” is displayed
Drive mode
display
To Next Page
Loading...
