Omron V600 Series Operation Manual

3-4SectionCommand Types and Responses
45
3-4-9 Management Data Limit (MDL)
This command is used to manage the number of DC overwriting operations on
the EEPROM of the ID Controller. Whether or not the number of DC overwriting
operations has exceeded 100,000 can be found by adding the number of DC
overwriting operations to the management area data designated by the user.
1 to 1 Procedure
Command Format
MDL1/2XXXXXX*s
R/W Head No. designation
Start address number
(jjj 0H to jjj 5H or jjj 8H to jjjH)
Designate the number to be added in HEX
(hexadecimal) code (00H, 01H, 02H, ..., FFH).
∗
Response Format
MD 7 5 *s
∗
End code
75: Within 100,000 times
76: Exceeded 100,000 times
1 to N Procedure
Command Format
MDL1/2XXXXXX
@ Unit No.
∗
FCS
R/W Head word designation
Start address number
Designate the number to be added in HEX
(hexadecimal) code (00H, 01H, 02H, ..., FFH).
00 to 15
Response Format
MD 7 5
∗
FCS@ Unit No.
End code
75: Within 100,000 times
76: Exceeded 100,000 times
00 to 15
Note Refer to 3-2-4 Data Carrier Usage Level Check Function for details.

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C