Omron V600 Series Operation Manual

3-4SectionCommand Types and Responses
46
3-4-10 Test Command (TS)
The test message sent from the host computer is returned without change. The
test command is used for such purposes as test communications with the host
computer.
Command Format
TSXXX X
∗
For 1 to 1 procedure
1 frame – 266 characters max.
Header Test message
.......
TSXXX X
@ Unit No.
∗
FCS
.......
Test message
Header
For 1 to N procedure
1 frame – 271 characters max.
00 to 15
Response Format
TSXXX X
∗
For 1 to 1 procedure
Header Test message
.......
For 1 to N procedure
TSXXX X
@ Unit No.
∗
FCS
.......
Test message
Header
00 to 15
3-4-11 Abort Command (XZ)
If a problem results in the response not being returning during communications
with the host computer or during local communications, the abort command can
be used to restore the ID Controller to the command waiting condition. There is
no response to the abort command.
Command Format
XZ
@ Unit No.
XZ
Header
∗
∗
FCS
Header
For 1 to N procedureFor 1 to 1 procedure
00 to 15

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C