6 Programming Features
111
14 Search Command from maxi-
mum frequency
Speed Search Command sig-
nal
88
15 Search Command from set
frequency
88
16 Acceleration/Deceleration
Hold Command
89
17 LOCAL/REMOTE selection 63
18 Communications/control cir-
cuit terminal selection
115
19 Emergency stop fault,
NO contact input
Inverter stops for an emergen-
cy stop signal input according
to the Stopping Method Selec-
tion (n005). When coast to
stop (n005 = 1) is selected,
the Inverter coasts to stop.
Digital Operator displays
(flashing).
-
20 Emergency stop alarm,
NO contact input
-
21 Emergency stop fault,
NC contact input
-
22 Emergency stop alarm,
NC contact input
-
23 PID control cancel 167
24 PID integral reset 167
25 PID integral hold 167
26 Inverter overheat alert
(OH3 alarm)
When the Inverter overheat
signal turns ON, (flash-
ing) is displayed at the Digital
Operator.
-
27 Acceleration/deceleration
time selection 2
77
28 Motor Switching Command
(Motor Selection)
99
29 Bi-directional PID prohibit
(ON: Prohibited)
163
30 Frequency offset input 1 85
31 Frequency offset input 2 85
32 Frequency offset input 3 85
Setting Name Description Ref.
page
To Next Page
Loading...
