240
104 0168 Torque Compensation Time
Constant
0.0 to 25.5 s 0.1 s 0.3 s
(Note 6)
No 58
105 0169 Torque Compensation Iron
Loss
0.0 to 6550 0.01 W (less
than 1000
W)/1 W
(1000 W or
more)
(Note 3) No 58
106 016A Motor Rated Slip 0.0 to 20.0 Hz 0.1 Hz (Note 3) Yes 60
107 016B Motor Line-to-neutral
Resistance
0.000 to 65.50
Ω
0.001 Ω
(less than 10
Ω)/0.01 Ω
(10 Ω or
more)
(Note 3) No 60
108 016C Motor Leakage Inductance 0.00 to
655.0 mH
0.01 mH
(less than
100 mH)/0.1
mH (100 mH
or more)
(Note 3) No 61
109 016D Torque Compensation
Voltage Limiter
0% to 250% 1% 150% No -
110 016E Motor No-load Current 0% to 99% 1% (Note 3) No 59
111 016F Slip Compensation Gain 0.0 to 2.5 0.1 0.0
(Note 6)
Yes 1 35
112 0170 Slip Compensation Time
Constant
0.0 to 25.5 s 0.1 s 2.0 s
(Note 6)
No 135
113 0171 Slip Compensation during
Regenerative Operation
0, 1 - 0 No -
114 0172 Number of Transmission Cy-
cle Error Detection (For SI-T/
V7)
2 to 10 - 2 No 191
115 0173 Stall Prevention above Base
Speed during Run
0, 1 - 0 No 133
116 0174 Acceleration/Deceleration
Time during Stall Prevention
0, 1 - 0 No 133
117 0175 Undertorque Detection
Function Selection 1
0 to 4 - 0 No 186
118 0176 Undertorque Detection Level 0% to 200% 1% 10% No 186
119 0177 Undertorque Detection Time 0.1 to 10.0 s 0.1 s 0.1 s No 186
No. Register
No. for
Trans-
mission
Name Setting Range Setting Unit Factory
Setting
Change
during
Opera-
tion
User
Set-
ting
Ref.
Page