Omron ZW Series - Hardware Configuration of ZW

Confidential C
AST*-******
Error! Reference source not found. Error! Reference source not found.
10
4.1. Hardware configuration of ZW
Operate the EtherCAT address setup volume of ZW, you can set the node address.
4.1.1. Setting of ZW node address
Operate the EtherCAT address setup volume of ZW, and then set the node address.
The example in this document, use the "01".
Precausions for correct use
The operation of the EtherCAT address setup volume, please operate the power is turned
OFF state of ZW.
Reference
It uses "01" to "0
9" in the manual setting only if in case where the number of connected
equipment is changed, you want to specify the node number to force.
In this case, please set number and slave are other EtherCAT connection so that they do not
overlap.