To Next Page
G
George PowellSep 12, 2025
What to do if the set numeric value is too small on Omron ZX-LD30V?
- Rronald85Sep 12, 2025
If the set numeric value is too small, input an appropriate numeric value.
What to do if the set numeric value is too small on Omron ZX-LD30V?
If the set numeric value is too small, input an appropriate numeric value.
What to do if one-sensor operation was attempted while selecting the A ? B or A + B operation on Omron Accessories?
If one-sensor operation was attempted while selecting the A ? B or A + B operation, perform one-sensor operation by reconnecting the Units and turning OFF two-sensor operation. If that's not possible, initialize the settings.
What to do if attempted two-sensor operation for two Amplifier Units with Intensity Mode ON on one Unit and OFF on the other for Omron ZX-LD30V Accessories?
If you've attempted two-sensor operation for two Amplifier Units with Intensity Mode ON on one Unit and OFF on the other, use the same Intensity Mode setting for both Amplifier Units.
General| Type | Laser Displacement Sensor |
|---|---|
| Ambient humidity | 35 to 85% RH (No condensation) |
| Weight | Approx. 100 g |
| Linearity | ±0.1% of F.S. |
| Light source | Semiconductor laser |
| Laser class | Class 2 |
| Measurement Range | ±5 mm |
| Output Type | Analog voltage |
| Power Supply Voltage | 12 to 24 VDC ±10% (ripple: 10% p-p max.) |
Covers OMRON's product warranty, liability limitations, and suitability for intended use.
Explains safety conventions (WARNING, CAUTION) and the importance of heeding safety information.
Details precautions for safe use of laser radiation, including eye protection and housing integrity.
Details procedures for connecting sensor heads, amplifier units, and installing them.
Covers scaling, hysteresis, hold functions, timers, and two-sensor operations for reflective sensors.
