OMS LINEA ESSE - Adjustments

OMS LINEA ESSE S.T.01/3S ED.0 REV.14 03/2017
51
ADJUSTMENTS
ADJUSTMENTS
Activity Frequency By whom? Note/references
General surgery water tap
End of the work day
Trained
operator
Close the dental unit water supply
tap
Instrument spray water pressure
adjustment
When necessary Trained
operator
Tap under the instrument table
(adjustment without tool)
Instrument air pressure adjustment When necessary Authorised
technician
Tap under the instrument table
(adjustment with tool, authorised
technician only)
Friction adjustment (accessible from the
exterior)
When necessary Trained
operator
Cup/spittoon water flow adjustment When necessary Trained
operator
Oscillating arm spring adjustment
(interior)
When necessary Authorised
technician
Main unit water pressure adjustment When necessary
Authorised
technician
Pressure regulator calibration
Main unit air pressure adjustment When necessary Authorised
technician
Pressure regulator calibration
INSTRUMENT SPRAY PRESSURE
The water flow on spray is adjusted by rotating the tap located under the its instrument: when turned
anticlockwise, the flow of water to the spray is gradually reduced; when turned clockwise.
MAIN UNIT AIR PRESSURE
The air pressure regulator is installed inside the cuspidor, it keeps air pressure equal while instruments are
used.
The air pressure regulator is calibrated at O.M.S. in case of technical proposed it can be changed later. This
operation must be performed by an authorized technician.
The air pressure is also used to avoid humidity get the instrument. Keep it clear.