FT
-
3500 ELECTROMAGNETIC FLOW METER
ONICON Incorporated 727.447.6140 Page 2 onicon.com
SAFETY INFORMATION
This meter was calibrated at the factory before shipment. To ensure correct use of the meter, please read this manual
thoroughly.
Regarding this Manual:
• This manual should be passed on to the end user.
• Before use, read this manual thoroughly to comprehend its contents.
• The contents of this manual may be changed without prior notice.
• All rights reserved. No part of this manual may be reproduced in any form without
ONICON’s written permission.
• ONICON makes no warranty of any kind with regard to this material, including, but not limited to, implied warranties
of merchantability and suitability for a particular purpose.
• All reasonable eort has been made to ensure the accuracy of the contents of this manual. However, if any errors
are found, please inform ONICON.
• ONICON assumes no responsibilities for this product except as stated in the warranty.
• If the customer or any third party is harmed by the use of this product, ONICON assumes no responsibility for any
such harm owing to any defects in the product which were not predictable, or for any indirect damages.
SAFETY PRECAUTIONS:
The following general safety precautions must be observed during all phases of installation, operation, service, and repair
of this product. Failure to comply with these precautions or with specic WARNINGS given elsewhere in this manual
violates safety standards of design, manufacture, and intended use of the product. ONICON Incorporated assumes no
liability for the customer’s failure to comply with these requirements. If this product is used in a manner not specied in
this manual, the protection provided by this product may be impaired.
The following messages are used in this manual:
WARNING
Messages identied as “WARNING” contain information regarding the personal safety of individuals involved in
the installation, operation or service of this product.
CAUTION
Messages identied as “CAUTION” contain information regarding potential damage to the product or other
ancillary products.
IMPORTANT NOTE
Messages identied as “IMPORTANT NOTE” contain information critical to the proper operation of the product.
To Next Page
Loading...
Need help?
General
