Onkyo CR-N765 User Manual

14
Getting started
5. Connecting the power cord
Always connect the power cord to an AC outlet only after
connecting it to the AC INLET terminal of the unit.
Turning on the unit may cause a momentary power surge
that might interfere with other electrical equipment on the
same circuit. If this is a problem, plug the unit into a
different branch circuit.
Disconnect the power cord only after putting the unit into
standby mode. To avoid electrical shock, always
disconnect the power cord from the AC outlet before
disconnecting the other end.
0 This unit consumes power when in standby mode.
6. Turning on the unit
1. Press the Í button.
0 If you turn on the unit when the input source is set to
USB or NET, “Now Initializing...” appears on the dis-
play. It will take 20–30 seconds until the unit
recognizes the input.
To return the unit to standby mode, press the Í button
again.
Do not use a power cord other than the one supplied
with this unit. Before connecting the power cord,
connect all of your speakers and components.
About the Auto Standby function: The Auto
Standby function is set to “On” by default. This means
when the unit is left without audio input for 2 hours, it
will automatically enter standby mode.
to an AC outlet
CR-N765_eng.book 14 ページ ２０１４年８月２９日 金曜日 午後２時１８分

Onkyo CR-N765 Specifications

General

Impedance	16 Ω
Receiver type	stereo
Output impedance	470 Ω
Input sensitivity	150 mV
4Ω speaker support	Yes
Audio output channels	2.0 channels
Signal-to-Noise Ratio (SNR)	100 dB
Power output per channel (20-20KHz@8 Ohm)	22 W
HDMI in	0
Audio (L/R) in	2
Digital audio optical in	1
Connectivity technology	Wired
Speakers connectivity type	RCA
Audio formats supported	AAC, ALAC, FLAC, LPCM, MP3, WAV, WMA
Bluetooth version	3.0+HS
Bluetooth profiles	APT-X
RDS features	PS, RT
AM band range	522 - 1611 kHz
FM band range	87.5 - 108 MHz
Supported radio bands	AM, FM
Preset stations quantity	40
Optical drive included	No
Display	-
Product color	Silver
Damping factor	58
Package weight	7 kg
Volume control	Rotary
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connector contacts plating	Gold
Package depth	309 mm
Package width	487 mm
Package height	232 mm
7000 g	Weight of the packaged product in gram.
Certification	CE, EAC, EMC
AC input voltage	220-230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.2 W
Power consumption (typical)	75 W

Weight and Dimensions

Depth	331 mm
Width	215 mm
Height	119 mm
Weight	5000 g